We hope these images will give you a better idea as to the possibilities with injection molding of advanced ceramics at ATS. Some of the images illustrate unique hole-shapes possible at ATS including a chevron, a rectangle, and a trilobe. Some of the images illustrate unique materials available at ATS including black zirconia, fibers and whiskers. Some of the images illustrate the level of complexity ATS is capable of producing including holes counts of 3, 6, or 164. There are parts that weigh .015 grams and others that weigh 300 grams. The possibilities are endless
Ultra High Purity Alumina Sleeve with 2.3mm Wall
Silicon Carbide Test Bar Polished to .05um Finish
High Purity Alumina Spinneret with 164 Holes As-Molded
High Purity Zirconia Bearing Polished to .025um Finish
High Purity Alumina Bushing As-Molded
Silicon Carbide Bushing As-Molded
Connecting Rod SiC Whisker Preform As-Molded
Variety of Materials Micromolded at ATS
Smaller High Purity Zirconia Bearing Polished to .025um Finish
As-Molded Optoelectric Connector with ID/OD alignment of < 3um
As-Molded Alumina Insulator with 6 – 400um Holes
Zirconia Applicator with Ground Tip & Laser Marked
Hole 125um with 12um Wall
Hole 125um As-Molded in Alumina
Holes 125um and 175um As-Molded in Black Zirconia
Trilobe Hole As-Molded in Alumina
Rectangular Hole As-Molded in Alumina
ID/OD Alignment of < 13um As-Molded in Aluminum Nitride
Piston Cap SiC Fiber Preform As-Molded
As-Molded Chevron Hole in Alumina
Complex Components from ATS
